Kidde 0918 Manuel d'utilisateur Page 1

For your convenience, write down the following information. If you call our Consumer Hotline, these are the first questions you will be asked.9 Volt

Carbon-zinc type EVEREADY 216 OR 1222; GOLD PEAK 1604P OR 1604SAlkaline type ENERGIZER 522; DURACELL MN1604,MX1604; GOLD PEAK 1604A; PANASONIC 6AM6,

Reinstall the lamp holder. It will snap easily into the base. Putworking batteries back in the alarm and remount the alarm on itsmounting trim ring.Re

• Smoke alarms are devices that can provide early warning of pos-sible fires at a reasonable cost; however, alarms have sensinglimitations. Ionizatio

• Have a family meeting and discuss your escape plan, showingeveryone what to do in case of fire.• Determine a place outside your home where you all c

a) smoking in bedb) leaving children home alonec) cleaning with flammable liquids, such as gasoline9. NRC INFORMATIONIonization type smoke alarms use

NOTIFY YOUR LOCAL FIRE DEPARTMENT AND INSURANCE COM-PANY OF YOUR SMOKE ALARM INSTALLATION.11. CAUTION (AS REQUIRED BY THE CALIFORNIA STATE FIRE MARSHA

FIVE YEAR LIMITED WARRANTYKIDDE Safety warrants to the original purchaser that the enclosedsmoke alarm (but not the battery) will be free from defects

This alarm detects products of combustion using the ionizationtechnique. It contains 0.9 microcurie of Americium 241, a radioac-tive material (see Sec

•Locate an alarm in every room where electrical appliances areoperated (i.e. portable heaters or humidifiers).•Locate an alarm in every room where som

•Put smoke alarms at both ends of a bedroom hallway or largeroom if the hallway or room is more than 30 feet (9.1 m) long.• Install Smoke Alarms on sl

• In very humid areas. Moisture or steam can cause nuisancealarms.• In insect-infested areas.• Smoke alarms should not be installed within 3 ft (.9m)

1. Remove the mounting plate from the back of the alarm byholding the mounting plate and twisting the alarm in the direc-tion indicated by the “OFF” a

NOTE: THE TAMPER RESIST PIN WILL HAVE TO BE REMOVEDIN ORDER TO CHANGE THE BATTERIES. USE LONG NOSE PLI-ERS TO PULL THE PIN OUT OF THE HOLE. IT IS NO

LED INDICATOR: This smoke alarm is equipped with a red LED indi-cator. The red LED is located under the test button and has twomodes of operation.Stan

6. MAINTENANCEALARM REMOVALIF TAMPER RESIST PIN HAS BEEN USED, REFER TO TAMPERRESIST LOCKING PIN IN SECTION 3 FOR PIN REMOVALINSTRUCTIONS.To replace t