Kidde PI2000CA Manuel d'utilisateur télécharger pdf (Page 12)

Installation

• Pull the AC Quick-Connect wire harness through the

center hole in the mounting bracket and secure the

bracket, making sure that the mounting screws are

positioned in the small ends of the keyholes before

tightening.

• Plug the AC Quick-Connect wire harness into the back

of the alarm (Image 5), making sure that the locks on

the connector snap into place. Then push the excess

wire back into the electrical box through the hole in the

center of the mounting plate.

• Install the alarm on the mounting plate and rotate the

alarm in the direction of the “ON” arrow on the cover

until the alarm ratchets into place (Image 4D). This

ratcheting function allows for aesthetic alignment. Note:

The alarm will attach to the mounting plate in 4

positions (every 90°).

• Turn on the AC power. The green AC Power On indicator

should be lit when the alarm is operating from AC power.

IMAGE 5

ATTACHING THE AC QUICK-CONNECT WIRE HARNESS

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Pas de commentaire

Kidde PI2000CA Manuel d'utilisateur Page 12