Kidde 1 Brochure télécharger pdf

Introduction

Your SupraSafe is the latest in Rapid Entry key

control. To fully utilize it’s built-in security features,

we recommend that reasonable care be given to the

location and method of mounting.

The vault is coated with a tough, baked polyurethane

abuse; however, it is always best to locate the vault

in an area which is sheltered from excessive moisture

and possible mechanical damage.

Important! Contact your local

department for

mounting location

and instructions.

Installation for Supra-Max, SupraSafe

1, SupraSafe 2HS/2HSR, and Supra-

Safe 2HS/TS-Vault

1. Mount the vault so that the moisture drain hole is

on the bottom.

2. Use a level to plumb the vault square.

3. Four 5/16-inch lag bolts have been provided for

surface mounting the vault.

Important! When installing the vault, do not

over-tighten the four mounting bolts as this

may distort the outside shell of the vault.

4. To secure the vault to a masonry/brick wall, it

is necessary to use the anchors provided with

the 5/16 lag bolts mounting kit. Drill a 1/2” hole

approximately 1-3/4” deep into the masonry/brick

wall. It is recommended to use a carbide/masonry

bit to prevent cracking or shattering. Gently pound

the anchor into the hole with a hammer so that it is

5. Caulk between the vault and the wall for better

once the vault has been installed.

7. We strongly recommend the wiring of the tamper

or licensed electrician. The circuit shall conform to

NEC class 2 or 3, or UL class 634 standards. In no

case shall the wiring supply more than 30 volts at

50 ma. Consult local codes and ordinances prior to

installations.

Figure 1. Side View of Mounted Vault

Drain hole

Chain mounting

bracket

P/N 10102664P1 • Feb 2013

Rapid Entry Systems

Installation Instructions

1 2

Résumé du contenu

Page 1 - Installation Instructions

IntroductionYour SupraSafe is the latest in Rapid Entry key control. To fully utilize it’s built-in security features, we recommend that reasonable ca

Page 2 - Installation

Instructions for SupraSafe 2HSR and SupraSafe 2HSR/TS VaultsThe SupraSafe 2HSR and SupraSafe 2HSR/TS vaults are designed to be recessed into a wall fo

Plus de documents pour Non Kidde 1

Kidde 1 Brochure (1 pages)

Commentaires sur ces manuels

Pas de commentaire

Kidde 1 Brochure

Naviguer en ligne ou télécharger Brochure pour Non Kidde 1. Kidde 1 Brochure Manuel d'utilisatio

Résumé du contenu

Plus de documents pour Non Kidde 1

Commentaires sur ces manuels

Produits connexes et manuels pour Non Kidde 1